|
|
 |
PC13A Fully Adjustable Electronic
Pressure Controller
Suits Single Phase Pumps to 1.5hp
High quality
Electronic Pressure Controller with Pressure Gauge.
This
controller can be matched with all water-network Pumps, and
has an adjustable cut-in pressure from 1.6 - 3.2 bar and IP65
rating.
 | Do
you have a water pump without a controller? |
| Does
your water pump give you a shower that "comes and goes"? |
| If you do not
already have a controller, you are not making the most of your
pump's abilities, and you could be risking damage to your pump. |
| If you install our
controller on your pump, it will turn on automatically when a tap is
opened, and turn off when the cutout pressure is reached when you
close the tap. |
| Run-dry protection
is built in to the controller, and it will detect insufficient water
flow if for example a tank runs out of water, and turn your pump off
before any serious damage occurs. |
| This
controller is pre-wired with female Australian plug for quick
connection to your pump, and it has a 2m
power cable with compliant 3-pin
Australian plug.
Specificiations: |
|
This
pressure controller is the best design presently available, (some
of which are very cheap and nasty)
|
|
Suits
all ACTF pumps and other brands of single phase pumps up to 1.5hp.
|
|
provides
fully automatic control of the pump
|
| Inlet/outlet
25mm BSP male (standard 1") |
|
Electrical
protection rating IP55
|
| Electronics
protected in its own enclosure, away from any possible water ingress |
|
In-built
check valve in the bottom of the controller
|
|
Loss-of-prime
protection – stops the pump on loss of flow (RUN-DRY)
|
|
Re-set
button with power, on and failure indicator lights
|
|
externally
adjustable via slotted screw in top for cut-in from1.1-3.5 bar
(Cut-out is a constant 2bar pressure differential from the cut-in
pressure)
|
|
No
need for a pressure bottle, the controller turns the pump on and
off automatically when a tap is opened or closed.
|
(C) Copyright MTF WATER BRISBANE
|
|
